Kaji Optimasi Desain Cetakan Injeksi Moulding pada Unit Pengolahan Limbah Plastik Dinas Kebersihan dan Pertamanan Kota Banda Aceh

Kaji Optimasi Desain Cetakan Injeksi Moulding pada Unit Pengolahan Limbah Plastik Dinas Kebersihan dan Pertamanan Kota Banda Aceh

Injection molding system;optimization sprue-nozzle location;mold design and molding defects

High impact of product damage by injection molds process on polymer waste processing unit was seriously affected to quality and sustainability production. In this study effect of injection mold design was minimized by investigated and redesign injection molding system. The main equipments of injection molding system which is available at Unit Pengolahan Limbah Plastik Dinas Kebersihan dan Permanan Kota Banda Aceh are polymer waste cutting, splitting and cleaning devices and injection molding machine. According to observation conducted previously on current injection molding product and mold found that failure of product caused by mis-design of mould. Products defects occurred are sink mark, weld line and air trap. Mold-Flow software was used to modeling and simulating injection mold process. Based on simulation result and discussion found that defected products have been able minimized. By modifying sprue location and redesign mold, products defect minimized and injection pressure still remain to push polymer to mold inlet  at range 0,72-0,48 Mpa

Ibrahim, Masri; Universitas Syiah Kuala

Irwansyah, -; Universitas Syiah Kuala

Safrizal, Eddi; Universitas Syiah Kuala

Jurnal Teknik Mesin Unsyiah; Vol 1, No 1 (2012); 31-35

2301-8224

2301-8224

Jurnal Teknik Mesin Unsyiah

2012-07-26

http://jurnal.unsyiah.ac.id/JTM/article/view/1422/1303

application/pdf

eng

info:eu-repo/semantics/article

info:eu-repo/semantics/publishedVersion

Peer-reviewed Article

http://jurnal.unsyiah.ac.id/JTM/article/view/1422